A family room
Warm underfoot with a rug over it, bright under the same lights, and no covering to lift when the sump has a bad week.
In a Kansas City basement the water comes up, not down. That single fact rules out most floor coverings and is the whole reason resin works here.
A basement slab sits in the ground, and ground moisture moves through concrete as vapour whether or not you can see it. Put a floor covering over it that cannot breathe and the vapour condenses underneath, which is where the smell, the cupping and the mould come from.
A bonded resin system does not trap a cavity for that to happen in. It is stuck to the slab across its whole area, and the primer is chosen for what the moisture test says rather than what is on the van.
Most basement enquiries are not really about flooring. They are about a floor plan of the house that has a whole storey written off.
Warm underfoot with a rug over it, bright under the same lights, and no covering to lift when the sump has a bad week.
Impact resistant enough for a loaded bar, and continuous, so there are no mat seams for a plate to catch on.
Boxes stop wicking up damp off the slab, which is the quiet reason basement storage usually ends up ruined.
Every one of these is something a lower level does to a floor that no other room in the house does.
Ground moisture moving up through the slab, all year, whether or not you ever see standing water.
Concrete in contact with the ground never gets warm. A sealed surface with a rug over it is the practical fix.
Nothing porous and no trapped cavity means nothing for spores to live in.
Furnace, water heater and sump in the same room. A seamless floor cleans around all of it.
Lower levels become gyms. The system is specified for that before anyone asks.
Old basements are rarely flat. Levelling happens at the prep stage, not by burying it.



A basement job that goes wrong almost always went wrong before the first coat.
It decides the primer and sometimes the whole system. On a lower level it is not a formality, and it happens before you are given a price.
A basement slab is usually older than the rest of the house and has moved. Cracks are cut out, filled and ground flush rather than coated over.
Where the slab meets the wall is where damp shows first. A coved edge turns the floor up the wall so there is no joint sitting in it.
Furnace, sump and water heater get worked around properly. A floor that stops short at a tidy line is a floor that will be lifted again.
Glenn gave me a fair and honest bid on my basement floor. He was very professional and was on time . Just thanking him for doing an excellent job on my basement and got it done early. The detail he put in was more than I expected. Thank you again and I’ll be calling again for my garage floor for sure.. thanks

Yes, but the prep is what decides it. We assess the slab and carry out crack repair, diamond grinding and joint filling as needed so the coating bonds to sound concrete rather than to whatever is sitting on top of it.
With proper surface prep and professional installation, 10 to 15 years or longer, even in high traffic commercial environments.
Often yes, but it depends what the moisture test shows and whether the source has been dealt with. Glen will tell you straight if a coating is the wrong answer for your slab rather than sell you one.
No colder than the slab already is, and warmer than bare concrete because it is sealed. Most people put a rug down in the sitting area and leave the rest bare.
Yes. Plenty of lower levels get the finished half done and the utility end left, or staged across two visits.
Four questions about the floor, then your details. Glen reads every one of these himself and comes out to measure before anything is final.
Type, rough size and what it is used for.
Usually the same working day, from the number below.
Then you get a fixed price, not a range.
Would rather talk it through? Call 816-500-1161, Monday to Friday 7am to 6pm.
Takes about a minute.
Free estimate, on site, from the owner.